Had a bit of time this afternoon and a mate came around, so we set about getting the engine in.
First up was getting the flywheel installed:
[img]http://images.plebeians.net/i.php?/upload/2019/08/17/20190817002750-92b741ad-xl.jpg[/img]
Then clutch:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002758-22faf37f-xl.jpg[/img]
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002806-e4eda2a3-xl.jpg[/img]
Then realising I had forgotten the dust cover sandwich plate… and having to pull it all off before the Loctite set up, and reinstalling with sandwich plate in place:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002814-150a6366-xl.jpg[/img]
Wrestled the engine back onto the dolly and then slot the subframe underneath and bolted it in place:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002830-e5f8a0ec-xl.jpg[/img]
Slotted the gear bag on, and then popped the new starter motor in… to find out that it must be for a similar but different model:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002844-158f32e2-xl.jpg[/img]
Eh, will deal with later, makes a good dust cover for now.
Slid the engine back in the way the B6 came out:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002851-cac81c2b-xl.jpg[/img]
Suspect the BP is a few mm higher as we had to remove the oil cap to slide it in.
Jack up in place and bingo, one engine installed:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002907-b644610d-xl.jpg[/img]
Finally mocked it up with manifolds and turbo:
[img]http://images.plebeians.net/_data/i/upload/2019/08/17/20190817002932-68fcf142-xl.jpg[/img]
Now that it is in the bay I can start with getting everything else set up. Wiring is up next, along with sorting out the rest of the intake bits, and then IC piping.