Ticked a few more little things off the list. First up was wrapping the dump pipe:
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030042221-642ede9c-xl.jpg[/img]
Should keep the heat down a little bit. Some is better than nothing anyway.
Then made up my MSD ignition leads, and mounted the coil packs:
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030041452-9a1bad63-xl.jpg[/img]
Got some Norma Cobra clamps for the oil and water drains:
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030041710-3bcc204a-xl.jpg[/img]
Will be able to slip heat sleeve over them later when im sure its not leaking.
Speaking of leaks though, i found a pinhole in the aluminium coolant hard line, that just refused to seal up. So i rebuilt it in stainless.
Built a little testing rig:
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030044756-cb53c0f5-xl.jpg[/img]
Just used some 32mm OD (25mm ID i think) PVC plumbing pipe and end caps, with a threaded wheel valve in one end.
Found a couple of pinholes:
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030044808-06fa8756-xl.jpg[/img]
Welded them up and it holds 60psi, or 4 bar.
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030044819-75083d0c-xl.jpg[/img]
Given its only a 16psi cap I think it will do just fine.
And test fitted:
[img]http://images.plebeians.net/_data/i/upload/2019/10/30/20191030041850-744558ad-xl.jpg[/img]
Waiting on some 32mm P clips to be able to build the mounting brackets for it, and then it should be good to go.
Once i can get it mounted up Ill be able to run the wiring harness and finish off some fiddly bits ahead of first start.